New and improved design. These special edition outputs are a single piece design. The work best with the Hot Racing steel main gear. The machining was done with a very tight tolerance so assembly will take a little finese.
These "OUTPUTS" will fit any AXIAL WRAITH transmission casing (Stock or Aftermarket)
and give you the same length as the WRAITH Transmission
This output replaces the stock one, and gives you 6mm ends for use with "REVO" or MIP Drive Shafts
They are best used with a "Hot Racing" Hardened STEEL gear set.(SOLD SEPARATELY)
but will work with stock as well !!
Made from Chrome Molly (4140)
These Outputs will take the demanding punishment your 1/8 scale electronics can dish out.....
2 6mm Outputs (Left/Right)
3 2mm screws
1 11 x 6 x 4 bearing (Needed to replace the End Bell Bearing)
1 16 x 10 x 5 bearing (Needed to replace the other End Bell Bearing)
Main Gear sold separately